SYNTH ZONE
Visit The Bar For Casual Discussion
Page 1 of 2 1 2 >
Topic Options
#299201 - 11/11/10 10:19 AM Leaving an arranger "on"
SemiLiveMusic Offline
Senior Member

Registered: 08/28/04
Posts: 2206
Loc: Louisiana, USA
I recall that for the Yamaha psr series with floppy drives, that drive spun continuously while on, so, it was not good to leave the keyboard on if not playing. Same for Audya and its hard drive? Yamaha s900, I suppose, does not have a drive, uses mem stick.
_________________________
~ ~ ~
Bill

Top
#299202 - 11/11/10 11:33 AM Re: Leaving an arranger "on"
tony mads usa Offline
Senior Member

Registered: 01/16/02
Posts: 14376
Loc: East Greenwich RI USA
If for no reason other than conserving electricity, when my kb is set up at home it is off except when I'm playing it ...
t.
PS my kn6000 has both a floppy and a hard drive ... not sure if they are 'spinning' all the time ...
t.
_________________________
t. cool

Top
#299203 - 11/11/10 11:44 AM Re: Leaving an arranger "on"
SemiLiveMusic Offline
Senior Member

Registered: 08/28/04
Posts: 2206
Loc: Louisiana, USA
I'm just talking about for several hours, not permanently... is this a bad idea.
_________________________
~ ~ ~
Bill

Top
#299204 - 11/11/10 12:26 PM Re: Leaving an arranger "on"
Bernie9 Offline
Senior Member

Registered: 09/21/02
Posts: 5520
Loc: Port Charlotte,FL,USA
I have been told through the years to keep the keyboard on through the day you are using it as switching on and off is harder on it. However, to turn it off at night.
_________________________
pa4X 76 ,SX900, Audya 76,Yamaha S970 , vArranger, Hammond SK1, Ketron SD40, Centerpoint Space Station, Bose compact

Top
#299205 - 11/11/10 01:01 PM Re: Leaving an arranger "on"
travlin'easy Offline
Senior Member

Registered: 12/08/02
Posts: 15576
Loc: Forest Hill, MD USA
ALL electronic devices are simply motors. While you cannot see the moving parts of an electronic engine, they are moving nonetheless. And, like any engine, when running, they are subject to wear. Additionally, the electronic engine is also subject to fluctuating line voltages and power surges--something a mechanical engine is not vulnerable to.

Now, turning an electronic device on subjects it to surges as well, but that surge is usually suppressed by certain components in the power supply. The best rule of thumb is if it's not turned on, the engine is not running. If it's plugged in, you CAN get zapped when you least expect. And finally, NO surge suppressor on the planet can protect your equipment from a nearby lightning strike. If lightning hits the power line pole on your street you can bet your bottom dollar that everything that's plugged into a power outlet will probably get fried--even when connected through a surge suppressor. It should know--it has happened to me twice in the past 30 years.

Cheers,

Gary
_________________________
PSR-S950, TC Helicon Harmony-M, Digitech VR, Samson Q7, Sennheiser E855, Custom Console, and lots of other silly stuff!

K+E=W (Knowledge Plus Experience = Wisdom.)

Top
#299206 - 11/11/10 01:06 PM Re: Leaving an arranger "on"
tony mads usa Offline
Senior Member

Registered: 01/16/02
Posts: 14376
Loc: East Greenwich RI USA
Quote:
Originally posted by SemiLiveMusic:
I'm just talking about for several hours, not permanently... is this a bad idea.


When using it at home or on a gig it usually is on for several hours ...
t.
_________________________
t. cool

Top
#299207 - 11/11/10 01:53 PM Re: Leaving an arranger "on"
Sander Offline
Member

Registered: 01/20/01
Posts: 189
Loc: Hoogeveen, Drenthe, The Nether...
My Roland VA-7 is almost the entire day on when I am at home. That is because I use my keyboard as a sort of speaker system for my computer. Never had a problem with it though

The only reasons I would turn it off is about the electricity bill, or because the disk is noisy..

Top
#299208 - 11/11/10 04:09 PM Re: Leaving an arranger "on"
leeboy Offline
Senior Member

Registered: 10/09/04
Posts: 2580
Loc: Ocala, FL USA
Electronics is one of my areas of expertise...and as a Ham Radio operator (licensed radio station) with significant antenna systems I have studied and implemented lightning protection all too much.
Once, I had a direct hit on the antenna at 72 ft. to see that ball of fire come down the tower and crash the ground was something you can't imagine! None of my equipment was damaged...due to the protection I have installed. Even though a $400 Polyphaser protection module was blown off the side of the house on fire! (That's where all the antenna feedlines come in)

IMHO, My sugestions are:

1) Get a good quality power supply conditioner/surge surpressor, This is not one of those $20 units. One intended for a high end home theatre setup is perfect.

2) Leave the keyboard ON during any normal period of playing...whether it's a whole day, a gig, a morning..whatever. Do not turn it on/off every few minutes. In general it is better to leave electonics on all the time, but be practical.I never turn my computers at the house off (unless storms are coming)

3) If a storm is approaching UNPLUG the power surpressor (all you goodies should be plugged into it anyways) Do not just turn off the p[ower switch of the surpressor, unplug it. Hey,if your goning to be gone for a few days ect...just unplug it.

Ligtning is not forgiving.

Lee S., KC9CDT

[This message has been edited by leeboy (edited 11-11-2010).]
_________________________
Lee S.

Top
#299209 - 11/11/10 04:33 PM Re: Leaving an arranger "on"
Stephenm52 Offline
Senior Member

Registered: 04/13/05
Posts: 5126
Loc: USA
When not in use I always unplug the keyboard and related equipment. As Lee says lightning is not forgiving.

Top
#299210 - 11/14/10 11:52 PM Re: Leaving an arranger "on"
mr9000 Offline
Member

Registered: 01/14/05
Posts: 318
Quote:
Originally posted by SemiLiveMusic:
I recall that for the Yamaha psr series with floppy drives, that drive spun continuously while on, so, it was not good to leave the keyboard on if not playing.

The 9000's floppy drive can be turned off.



[This message has been edited by mr9000 (edited 11-14-2010).]

Top
Page 1 of 2 1 2 >

Moderator:  Admin, Diki, Kerry 



Help keep Synth Zone Online